Find the fuse box locations and protected circuits for the Volkswagen Caddy 2K (2004–2014). Use the numbered diagram to inspect a position, then check the rating and equipment notes in the searchable table.
Check your version. Third-generation Caddy 2K, 2004–2014, using the illustrated 58-position cabin carrier. Van, passenger, early and facelift versions can use different assignments. The engine-bay block has separate layout variants and must be identified independently.
Fuse box locations
The cabin fuse and relay assembly is under the dashboard on the driver side. The engine-bay fuse assembly is beside the battery, with high-current links connected to the battery supply. Additional relays may be fitted in the driver footwell.
Passenger-compartment fuse box diagram
Hover over a numbered fuse, tap it or focus it with the keyboard to see its protected circuit. The numbered arrangement follows the illustrated carrier; the shapes and dimensions are simplified.
Scroll inside the diagram to see all positions. “var.” means the listed rating changes with equipment. A dash means no verified rating is given here. Use the specified rating and fuse type for your vehicle; colour alone is not sufficient.
Select a fuse position
Its rating and protected circuit will appear here.
No matching circuit. Try another component name or position number.
Open the complete cabin fuse table
Alternative ratings and equipment assignments describe different vehicle versions. They are not interchangeable. An unassigned position in this layout may be used in another version.
| Position | Panel | Rating | Protected circuit / equipment notes |
|---|---|---|---|
| Cabin | 15 A | engine start button | |
| Cabin | 5 A | trailer recognition control unit | |
| Cabin | 5 A | heater switch and operating mode selector, high pressure sensor | |
| Cabin | 5 A | control unit of the electronics of the mobile phone control | |
| Cabin | 15 A | air flow meter | |
| Cabin | 5 A | airbag control unit | |
| Cabin | — | driver and passenger seat heating regulator, air conditioning control unitThe rating is not specified in this schedule. Check the fitted fuse and vehicle documentation. | |
| Cabin | 5 A | heating resistor of the left and right windshield washer jets | |
| Cabin | 5 A | airbag control unit, power steering unit | |
| Cabin | 5/10 A | control unit for mobile phone control electronics, 10A reversing light switch | |
| Cabin | 10 A | power steering control unit | |
| Cabin | — | Not assigned in this layout | |
| Cabin | — | Not assigned in this layout | |
| Cabin | 5 A | ASR switch, ASR and ESP off button, ABS control unit with EDS | |
| Cabin | 10 A | reversing light switch, relay for operation in auxiliary heater mode (from May 2004) | |
| Cabin | 5 A | diagnostic data bus interface | |
| Cabin | 7.5 A | left side marker light and rear fog light bulb (vehicles without central locking) | |
| Cabin | — | Not assigned in this layout | |
| Cabin | — | Not assigned in this layout | |
| Cabin | — | Not assigned in this layout | |
| Cabin | 5 A | selector | |
| Cabin | 5 A | radio signal receiving device for additional liquid heater | |
| Cabin | 10 A | brake light switch, left brake light bulb, right brake light bulb, upper brake light bulb, ABS control unit | |
| Cabin | 10 A | light switch, air conditioning control unit, diagnostic connector (T16/16) | |
| Cabin | 30 A | driver's seat heating control unit, front passenger's seat heating control unit | |
| Cabin | 10 A | engine control units, injectors | |
| Cabin | 15 A | rear window wiper motor (from May 2004) | |
| Cabin | 5 A | light switch (vehicles with central locking) | |
| Cabin | — | Assignment not specifiedThe rating is not specified in this schedule. Check the fitted fuse and vehicle documentation. | |
| Cabin | 20 A | fog light switch, lighting switch | |
| Cabin | 25 A | relay for operation in autonomous heater mode (until April 2004), after – onboard electrical system control unit | |
| Cabin | 15 A | washer pump | |
| Cabin | 40 A | heater switch and operating mode selector, air conditioning control unit | |
| Cabin | — | Not assigned in this layout | |
| Cabin | 40 A | ventilation blower, relay for operation in autonomous heater mode | |
| Cabin | — | Not assigned in this layout | |
| Cabin | 15 A | right dipped beam headlight bulb (vehicle without central locking) | |
| Cabin | 15 A | left dipped beam headlight bulb (only vehicles without central locking) | |
| Cabin | — | Not assigned in this layout | |
| Cabin | 20 A | trailer recognition control unit | |
| Cabin | 20 A | Trailer socket | |
| Cabin | 15/30 A | 12 V socket (next to the parking brake lever), socket (12 V) on the left in the luggage compartment | |
| Cabin | 15 A | electric fuel pump relay 2 (BCA, BGU), fuel pump | |
| Cabin | 5 A | interior security system sensor, vehicle tilt sensor | |
| Cabin | 5 A | antenna selection control unit | |
| Cabin | 7.5 A | onboard electrical system control unit | |
| Cabin | 25 A | cigarette lighter | |
| Cabin | 20 A | headlight cleaning system relay, headlight washer pump | |
| Cabin | 10 A | driver's door control unit, front passenger's door control unit | |
| Cabin | 25 A | central control unit for comfort systems | |
| Cabin | 30 A | seat heating control unit | |
| Cabin | 25 A | ventilation blower relay, onboard electrical system control unit | |
| Cabin | 25/30 A | central control unit for comfort systems / 30A Lamps | |
| Cabin | — | Not assigned in this layout | |
| Cabin | — | Not assigned in this layout | |
| Cabin | — | Not assigned in this layout | |
| Cabin | 30 A | emergency data logger | |
| Cabin | — | Not assigned in this layout |
Common Caddy fuse checks
Position 47 is listed for the cigarette lighter at 25 A. Additional 12 V sockets use position 42 in the listed 15 A or 30 A variants, depending on equipment and socket location. Position 24 (10 A) includes the diagnostic connector; position 32 (15 A) supplies the washer pump.
Position 29 is present in the drawing but its assignment is not specified in the available table. Position 7 also lacks a confirmed rating. Both remain clearly marked so a missing value is not mistaken for permission to install a fuse.
How do I choose the right fuse rating?
Match the exact vehicle, fuse carrier and circuit before replacing a fuse. Where several ratings are shown, use the vehicle-specific allocation and the correct fuse type. A higher rating can leave the wiring unprotected; it is not a fix for a fuse that keeps blowing.
How should I check or replace a fuse?
- Park safely and switch off the ignition and the affected equipment.
- Identify the correct carrier and position. Remove the fuse with a suitable puller.
- Inspect the element or check continuity of the removed fuse. Fit the specified type and identical rating.
- Refit the cover and test the circuit. If the replacement blows again, diagnose the fault before replacing it again.
High-current links, airbag and belt-tensioner circuits require the relevant service procedure. Do not bridge fuse terminals.
The fuse is intact. Why is the equipment still not working?
Check the ignition setting and whether other devices on the same supply work. A damaged socket, connector, earth connection, switch, relay or control module can interrupt the circuit even when its fuse is intact. Use the matching wiring diagram and appropriate circuit tests before replacing parts.